Date: July 12, 2016

SAFETY DATA SHEET

SECTION 1 - IDENTIFICATION
Product identifier used on the label: Speedy Sanitizer
Other means of Identification: SS512
Recommended use of the chemical and restrictions on use: For professional use only.
Manufacturer/Supplier: Acme Industries
Address: 123 Memory Lane, Ottawa, ON T6A3Y5
Telephone: (613)123-4567 Fax: (613)123-5678
24 Hr. Emergency Tel. #: Info 1-800-123-4567 (North America), 001-1-613-123-4567 (International)
SECTION 2 - HAZARDS IDENTIFICATION
Classification of the chemical:
Skin Corrosion/Irritation 1
Eye Damage/Irritation 1
Label Elements:
Signal Word: Danger
Hazard statement(s):
H314 Causes severe skin burns and eye damage
Precautionary statement(s):
P260 Do not breathe dust/fume/gas/mist/vapours/spray
P264 Wash exposed areas thoroughly after handling
P280 Wear protective gloves/protective clothing/eye protection/face protection
P301+330+331 IF SWALLOWED: Rinse mouth. Do NOT induce vomiting
P303+361+353 IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower
P304+340 IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing
P305+351+338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses if present and easy to do – continue rinsing
P310 Immediately call a poison center or doctor/physician
P321 Specific treatment (see section 4 of SDS)
P363 Wash contaminated clothing before reuse
P405 Store locked up
P501 Dispose of contents/container in accordance with local regulation
Hazard pictogram(s):
corrosive symbol       exclamation symbol
Other hazards not otherwise classified: None Known
Unknown Acute Toxicity: 0%
SECTION 3 - COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Name, Common Name & Synonyms: CAS # Concentration %
Alkyl dimethyl ethylbenzyl ammonium chloride (40%), Alkyl dimethyl benzyl ammonium chloride (40%), Ethanol (9%), Alkyldimethyl amines -C12-18 (<1.6%) 85409-23-0, 6839101-5, 64-17-5, 68391-04-8 7-13
** If the chemical name/CAS # is “proprietary” and/or the weight % is shown as a range, this information has been withheld as a trade secret.
SECTION 4 - FIRST-AID MEASURES
Description of first aid measures:
If swallowed: Rinse mouth. Do NOT induce vomiting. Immediately call a poison center or doctor/physician.
If on skin (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. If skin irritation occurs get medical advice/attention.
If inhaled: Remove person to fresh air and keep comfortable for breathing. Immediately call a poison center or doctor/physician.
If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a doctor/physician.
Most Important symptoms and effects, both acute and delayed: Causes severe skin burns and eye damage.
Indication of any immediate medical attention and special treatment needed: Treat symptomatically
SECTION 5 - FIRE-FIGHTING MEASURES
Extinguishing media:
Suitable extinguishing media: Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.
Unsuitable extinguishing media: Not determined
Special hazards arising from the substance or mixture: None known
Flammability classification: Not flammable
Hazardous combustion products: Carbon oxides, oxides of phosphorus other unidentified organic compounds.
Special protective equipment and precautions for firefighters:
Protective equipment for fire-fighters: Firefighters should wear proper protective equipment and selfcontained breathing apparatus with full face piece operated in positive pressure mode.
Special fire-fighting procedures: Move containers from fire area if safe to do so. Cool closed containers exposed to fire with water spray. Do not allow run-off from firefighting to enter drains or water courses. Dike for water control.
SECTION 6 - ACCIDENTAL RELEASE MEASURES
Personal precautions, protective equipment and emergency procedures: All persons dealing with the clean-up should wear the appropriate chemically protective equipment. Keep people away from and upwind of spilt/leak. Restrict access to area until completion of clean-up. Refer to protective measures listed in sections 7 and 8.
Methods and material for containment and cleaning up: Do not allow material to contaminate ground water system. If necessary, dike well ahead of the spill to prevent runoff into drains, sewers, or any natural waterway or drinking supply. Ventilate the area. Prevent further leakage or spillage if safe to do so. Soak up with inert absorbent material. Do not use combustible absorbents, such as sawdust. Pick up and transfer to properly labeled containers. Contaminated absorbent material may pose the same hazards as the spilled product. Contact the proper local authorities.
Special spill response procedures: In case of a transportation accident, contact Infotrac 1-800-535-5053 (North America), 011-1-352-323-3500 (International). If a spill/release in the US in excess of the EPA reportable quantity is made into the environment, immediately notify the national response center in the United States (phone: 1-800424-8802).
SECTION 7 - HANDLING AND STORAGE
Precautions for safe handling: Handle in accordance with good industrial hygiene and safety practice. Use protective equipment recommended in section 8. Avoid contact with skin, eyes or clothing. Do not breathe dust/fume/gas/mist/vapors/spray. Wash face, hands, and any exposed skin thoroughly after handling.
Conditions for safe storage: Keep container tightly closed and store in a cool, dry and well-ventilated place. Store locked up. Keep out of reach of children.
Incompatible materials: Oxidizing agents. Do not mix with other chemicals or cleaners
SECTION 8 – EXPOSURE CONTROLS AND PERSONAL PROTECTION
Exposure Limits:
  OSHA PEL
Chemical Name CAS # TWA STEL PEL STEL
Alkyl dimethyl ethylbenzyl ammonium chloride (40%), Alkyl dimethyl benzyl ammonium chloride (40%), Ethanol (9%), Alkyldimethyl amines -C12-18 (<1.6%) 85409-23-0,68391-01-5, 64-175, 68391-04-8   1000 ppm (Ethanol) 1000 ppm (Ethanol)  
Exposure controls:
Ventilation and engineering measures: Use only in well-ventilated areas. Apply technical measures to comply with the occupational exposure limits. Where reasonably practicable this should be achieved by the use of local exhaust ventilation and good general extraction. In case of insufficient ventilation wear suitable respiratory equipment.
Respiratory protection: If airborne concentrations are above the permissible exposure limit or are not known, use NIOSH-approved respirators. Respirators should be selected based on the form and concentration of contaminants in air, and in accordance with OSHA (29 CFR 1910.134). Advice should be sought from respiratory protection specialists.
Skin protection: Wear protective gloves. Where extensive exposure to product is possible, use resistant coveralls, apron and boots to prevent contact. The suitability for a specific workplace should be discussed with the producers of the protective regimes.
Eye face protection: Wear eye/face protection. Wear as appropriate tightly fitting safety goggles; Safety glasses with side-shields.
Other protective equipment: Ensure that eyewash stations and safety showers are close to the workstation location. Other equipment may be required depending on workplace standards.
General hygiene considerations: Do not breathe vapours or spray mist. Avoid contact with skin, eyes and clothing. Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly after handling. Remove and wash contaminated clothing before re-use. Handle in accordance with good industrial hygiene and safety practice.
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Clear, colorless liquid
Odor: Bland
Odor threshold: No applicable information available
pH: 7-8
Melting/Freezing point: No applicable information available
Initial boiling point and boiling range: 100 C
Flash point: None to boiling
Flashpoint (Method): No applicable information available
Evaporation rate (BuAe = 1): Similar to water
Flammability (solid, gas): Not flammable
Lower flammable limit (% by vol.): Not Flammable
Upper flammable limit (% by vol.): Not Flammable
Vapor pressure: No applicable information available
Vapor density: No applicable information available
Relative density: 1.0
Solubility in water: Soluble
Other solubility(ies): No information available
Partition coefficient: No information available
Auto ignition temperature: No information available
Decomposition temperature: No information available
Viscosity: Water thin
Volatile organic Compounds (%VOC's): 11 g/L
Other physical/chemical comments: No information
SECTION 10 - STABILITY AND REACTIVITY
Reactivity: Not normally reactive
Chemical stability: Stable
Possibility of hazardous reactions: No hazardous polymerization
Conditions to avoid: Keep out of reach of children. Do not use in areas without adequate ventilation. Avoid contact with incompatible materials.
Incompatible materials: Fluorine, strong oxidizing or reducing agents, bases, metals, sulfur trioxide, phosphorus pentoxide
Hazardous decomposition products: None known. Refer to 'Hazardous Combustion Products' in Section 5
SECTION 11 - TOXICOLOGICAL INFORMATION
Information on likely routes of exposure:
Routes of entry - inhalation: Avoid breathing vapors or mists
Routes of entry - skin & eye: Avoid contact with skin or eyes
Routes of entry - Ingestion: Do not taste or swallow
Potential Health Effects:
Signs and symptoms of short term (acute) exposure:
Symptoms: Please see section 4 of this SDS sheet for symptoms
Potential Chronic Health Effects:
Mutagenicity: Not expected to be mutagenic in humans
Carcinogenicity: This product contains ethanol which is known to be a carcinogen when consumed orally; there is no evidence to suggest ethanol is carcinogenic as used in this product.
Reproductive effects: No applicable information available
Sensitization to material: No applicable information available
Specific target organ effects: No data available to indicate product or components will have specific target organ effects
Medical conditions aggravated by overexposure: Pre-existing skin, eye or respiratory conditions
Toxicological data:
See the following table for individual ingredient acute toxicity data.
Chemical name CAS # LD50 (Oral, rat) LD50 (Dermal. Rabbit) LC50 (4hr, Inhal., rat)
Alkyl dimethyl ethylbenzyl ammonium chloride (40%), Alkyl dimethyl benzyl ammonium chloride (40%), Ethanol (9%), Alkyldimethyl amines -C12-18 (<1.6%) 85409-23-0, 68391-01-5, 64-17-5, 68391-048 501    
*All empty cells no applicable information available
Other important toxicological hazards: None reported
SECTION 12 - ECOLOGICAL INFORMATION
Ecotoxicity: No applicable information available
Persistence and degradability: No applicable information available
Bioaccumulation potential: No applicable information available
Mobility in soil: No applicable information available
Other Adverse Environmental effects: No applicable information available
SECTION 13 - DISPOSAL CONSIDERATIONS
Handling for disposal: Handle in accordance with good industrial hygiene and safety practice. Refer to protective measures listed in sections 7 and 8. Empty containers retain residue (liquid and/or vapour) and can be dangerous.
Methods of disposal: Dispose in accordance with all applicable federal, state, provincial and local regulations. Contact your local, state, provincial or federal environmental agency for specific rules.
RCRA: If this product, as supplied, becomes a waste in the United States, it may meet the criteria of a hazardous waste UN defined under RCRA, Title 40 CFR 261. It is the responsibility of the waste generator to determine the proper waste identification and disposal method. For disposal of unused or waste material, check with local, state and federal environmental agencies.
SECTION 14 - TRANSPORTATION INFORMATION
Special Shipping Information: Keep from freezing
T.D.G. Classification: Not regulated under T.D.G.
D.O.T. Classification: Not regulated under D.O.T.
SECTION 15 - REGULATORY INFORMATION
EPA/Health Canada Statement:
This chemical is registered by the Environmental Protection Agency/Health Canada and is subject to certain labeling requirements by law. These requirements differ from the classification criteria and hazard information required for safety data sheets and for workplace labels of non-pesticide chemicals. For more information see product label.
SECTION 16 - OTHER INFORMATION
Legend:
ACGIH: American Conference of Governmental Industrial Hygienists
CAS: Chemical AbstractServices
CERCLA: Comprehensive Environmental Response, Compensation, and Liability Act of 1980
CFR: Code of Federal Regulations
CSA: CanadianStandardsAssociation
DOT: Department of Transportation
ECOTOX: U.S. EPA Ecotoxicology Database
EINECS: EuropeanInventory ofExisting CommercialchemicalSubstances
EPA: Environmental Protection Agency
HSDB: Hazardous Substances Data Bank
IARC: International Agency for Research on Cancer
IUCLID: International Uniform Chemical Information Database
LC: Lethal Concentration
LD: Lethal Dose
NIOSH: National Institute of Occupational Safety and Health
NTP: National Toxicology Program
OECD: Organization for Economic Co operation and Development
OSHA: Occupational Safety and Health Administration
PEL: Permissible exposure limit
RCRA: Resource Conservation and Recovery Act
RTECS: Registry of Toxic Effects of Chemical Substances
SARA: SuperfundAmendments and ReauthorizationAct
SDS: Safety Data Sheet Material Safety Data Sheet
STEL: Short Term Exposure Limit
TDG: Canadian Transportation of Dangerous Goods Act & Regulations
TLV: Threshold Limit Values
TWA: Time Weighted Average
WHMIS: Workplace Hazardous Materials Identification System
Prepared By: Acme Industries
Tel: (613)-123-4567